ICHARG

From VASP Wiki
Revision as of 09:56, 25 July 2024 by Csheldon (talk | contribs)

ICHARG = 0 | 1 | 2 | 4 

Default: ICHARG = 2 if ISTART=0
= 0 else

Description: ICHARG determines how VASP constructs the initial charge density.


Calculate the charge density from initial wave functions.
If ISTART is internally reset due to an invalid WAVECAR file, ICHARG will be set to ICHARG=2.
Read the charge density from CHGCAR file, and extrapolate from the old positions (on CHGCAR) to the new positions using a linear combination of atomic charge densities.
In the PAW method, there is, however, one important point to keep in mind: For the on-site densities (that is, the densities within the PAW sphere), only l-decomposed charge densities up to LMAXMIX are written. Upon restart, the energies might, therefore, differ slightly from the fully converged energies. The discrepancies can be large for the DFT+U method. In this case, one might need to increase LMAXMIX to 4 (d-elements) or even 6 (f-elements).
Tip: To improve convergence and reduce the number of electronic steps, it is recommended to set ICHARG = 1 when starting calculations repeatedly with small changes in the input parameters.
Take superposition of atomic charge densities.
Read potential from file POT. The local potential on the file POT is written by the optimized-effective-potential methods (OEP), if the flag LVTOT=.TRUE. is supplied in the INCAR file. Supported as of VASP.5.1.
non-selfconsistent calculations: Adding 10 to the value of ICHARG, e.g., ICHARG=11 or 12 (or the less convenient value 10) means that the charge density will be kept constant during the entire electronic minimization.
There are several reasons why to keep the charge density constant:
To obtain the eigenvalues (for band-structure plots) or the density of states (DOS) of a given charge density read from CHGCAR. The self-consistent CHGCAR file must be determined beforehand by a fully self-consistent calculation with a k-point grid spanning the entire Brillouin zone.
Non-self-consistent calculations for a superposition of atomic charge densities. This is in the spirit of the non-self-consistent Harris-Foulkes functional. The stress and the forces calculated by VASP are correct, and it is possible to perform an ab-initio MD for the non-selfconsistent Harris-Foulkes functional.
Tip: If ICHARG is set to 11 or 12, it is strongly recommended to set LMAXMIX to twice the maximum l-quantum number in the pseudopotentials. Thus, for s and p elements LMAXMIX should be set to 2, for d elements LMAXMIX should be set to 4, and for f elements LMAXMIX should be set to 6.

The initial charge density is of importance in the following cases:

  • If ICHARG≥10 the charge density remains constant during the run.
  • For all algorithms except IALGO=5X the initial charge density is used to set up the initial Hamiltonian that is used in the first few non-selfconsistent steps, c.f., NELMDL tag.

Related tags and articles

CHGCAR, ISTART, LCHARG, LMAXMIX, NELMDL, INIWAV

Examples that use this tag